In-Process Inspection If the production run consists of more than 50 parts, an in-process inspection will be performed at a rate designated by Quality Control. The inspection will be based on the complexity and tolerance of the part. This inspection shall be noted on the reverse side of the Manufacturing Operations Sheet. All in-process inspections will be so noted. The information required is as follows: CRITERIA PIECE # ACC/REJ DATE BY The inspected parts will be identified as acceptable or unacceptable so that no co-mingle will occur in the production run. If a reject is found during an in-process inspection, the lot will be 100% inspected for that criteria and the parts rejected will be segregated and identified as non-conforming material. This must be so noted on the reverse side of the Manufacturing Operations Sheet and the foreman notified immediately. Back to QC Table of Contents This page is best viewed with a screen resolution of 800x600 or higher with Netscape 4.0 or Internet Explorer 4.0.